search

denkyem / home-assistant-moonraker

Integration between Moonraker and Home Assistant
119 stars 20 forks source link

Configure Home Assistant Card after moonraker.yaml added? #4

Open rrik opened 2 years ago

rrik commented 2 years ago

Hello, can you post some steps on how to create a card after moonraker.yaml is configured and added? I am completely stuck on this step. Thank you!

emersonsc commented 2 years ago

I'm asking the same. I put the code in via the raw code editor and nothing comes up

sdoup commented 2 years ago

i had the same problem too but i sort it out after of couple hours. you have to install appdemon4 and create a dash there so you can copy paste the 3dprinter.dash. there is no need to do that,since after the moonraker.yaml all the infos are available an you can make your own cards