search

dgatf / msrc

Multi Sensor for RC with RP2040 - FrSky D, SmartPort, XBUS, SRXL, IBUS, SBUS, Multiplex Sensor Bus, Jeti Ex Bus, Hitec, CRSF, Sanwa
GNU General Public License v3.0
176 stars 43 forks source link

Some detailed info for readme... #109

Closed DarthRye closed 1 year ago

DarthRye commented 1 year ago

S!

Dont know where to find that info, so sorry if this is not the place.

I would know the list of materials needed and its detailed specs ( resistor wattage for example)

Also would be nice to find some pictures of where to connect telemetry on ESC, for example Hobbywing Flyfun v5 ESC, where readme says its not the programa cable nor the throttle one.

Thx for the effort.

aepub commented 1 year ago

RP2040 can generally be found on shopping websites; A resistance of 1/6 or 1/8 is sufficient; There is a chart in the first section of readme that provides detailed instructions on how to connect the line; How to connect the Hobbywing Flyfun v5 ESC to the aircraft model is not within this range. Connecting RP2040 can be used to run MSRC_ There is a detailed image explanation when using gui. exe; However, this code does not have much problem in Arduino. After the author ported it to RP2040, there were many problems, such as no LED prompt, GPS cannot display, and so on.

dgatf commented 1 year ago

Based on the esc manual you have to connect the program wire (3) to GPIO5 and select Hobbywing V4 protocol to have full telemetry