Jeti issues

[dgatf]

From @aepub

Currently, I have found that:

• GPS positioning is relatively slow, sometimes longitude and latitude only appear for a long time on JETI, and sometimes when the TX plug is unplugged and plugged in again, data such as longitude and latitude and date will appear
• The voltage display data jumps, not at a fixed value
• Unable to display the current value, I am not sure if it is the reason for the setting

[dgatf]

Which sensors you have enabled for voltage and current? esc or analog?

[aepub]

1. I use the BeiTian BE-220 GPS module with a Baud of 9600 and a TX cable connected to 6 pins. The PPS light flashes when there is a signal, but the remote control does not display longitude and latitude, date, time, etc., but occasionally displays them; If the GPS is powered off and restarted, there will be no signal;

2. 

3. I use ACS758-100B as the current sensor to measure current, and 78K/10K as the voltage divider to measure voltage. The MSRC has set the measurement current, and the remote control can measure 18 items, but there is no current. In addition, the measured voltage will jump up and down, such as 15.00V, which will display 15.02 or 14.98, etc.

4. MS5611 has been damaged, I will wait for a new module before testing.

5. I downloaded the latest RGB version, but there is still no indicator light displayed.

[dgatf]

For some reason msrc is not reading the gps, as shown in debug. Check connections

[dgatf]

There was some issues with the gps. Fixed with commit https://github.com/dgatf/msrc/commit/8d7dff8d529ff5bad787930bc59cdbd53e4dab83