Hi.
I don't know if the issue should be reported here or on valetudo's project.
I've tried to install valetudo on my vacuum (Gen2) building the firmware with DustBuilder.
If I install FW1886 (with valetudoRE) I haven't any issue. Everything works fine.
But with FW2008 (valetudo or valetudoRE) I'm stuck. If I connect to the AP created by the robot, I can control it, but once I give him the network SSID and password, it doesn't connect. The log (syslog) on the robot shows errors when connecting to the network, but not very specific (and I tried many times, so the password is not the issue).
Could be possible that this firmware requires internet? My router's DHCP gives an ip but no internet access (and I have no intention to do that). If that's the case, how can I solve it?
Hi. I don't know if the issue should be reported here or on valetudo's project. I've tried to install valetudo on my vacuum (Gen2) building the firmware with DustBuilder. If I install FW1886 (with valetudoRE) I haven't any issue. Everything works fine. But with FW2008 (valetudo or valetudoRE) I'm stuck. If I connect to the AP created by the robot, I can control it, but once I give him the network SSID and password, it doesn't connect. The log (syslog) on the robot shows errors when connecting to the network, but not very specific (and I tried many times, so the password is not the issue). Could be possible that this firmware requires internet? My router's DHCP gives an ip but no internet access (and I have no intention to do that). If that's the case, how can I solve it?