ESP8266 Wemos D1 to setup the Radiosonde RS41 at startup. It will modify the TX registers 75, 76, and 77 to select an arbitrary frequency, usually inside the radio amateur band
22
stars
4
forks
source link
D1 Mini only sets frequency after pressing reset button #1
Hi,
I like the solution you found to be able to set the TX frequency of the RS41 direct after starting.
My problem is that the frequency is not changed after starting, blue led flashed rapidly, but, when still connected to the RS41, after pressing the reset on the D1 mini the frequency is changed.
However, after the reset the D1 cannot be find on my wifi network and aslo not in AP mode on my smartphone.
If I power off the RS41 the D1 also powers of, after turning power on at the RS41 the D1 powers on but fails to set frequency but does connect to my wifi so I can view it on my webbrowser, however as said, cannot change the frequency.
Hi, I like the solution you found to be able to set the TX frequency of the RS41 direct after starting.
My problem is that the frequency is not changed after starting, blue led flashed rapidly, but, when still connected to the RS41, after pressing the reset on the D1 mini the frequency is changed.
However, after the reset the D1 cannot be find on my wifi network and aslo not in AP mode on my smartphone.
If I power off the RS41 the D1 also powers of, after turning power on at the RS41 the D1 powers on but fails to set frequency but does connect to my wifi so I can view it on my webbrowser, however as said, cannot change the frequency.
Any idea what I am missing over here ?
Thanks!