Use mezzanine card for debugging signals

dinyar / uGMTfirmware

Firmware for the CMS uGMT.

0 stars 4 forks source link

Use mezzanine card for debugging signals #264

Closed dinyar closed 9 years ago

dinyar commented 9 years ago

In the future the uGMT MP7 card should be equipped with a mezzanine card that provides lemo as well as LVDS outputs. These could be used to easily access debugging signals. It should be discussed which signals would be useful.

dinyar commented 9 years ago

The new mezzanine card to be used will feature three LEMO outputs but no LVDS ones. It may be the most useful to have the following three signals routed to the outputs:

[x] A pseudo-trigger signal (sent if an event contains a muon)
[x] The BC0 signal from TCDS
[x] The valid bit

With the two last signals it may be easier to establish timing.

dinyar commented 9 years ago

This builds in both simulation and firmware. Untested for lack of a mezzanine card, so I'm closing this.