Open vmayoral opened 9 years ago
(left side corresponds with rev. 1.2, right side rev. 1.4):
rev. 1.2
rev. 1.4
In rev. 1.2 the VDD_ADC is not connected properly (that signal provides 1.8 V, the voltage divider is not needed).
VDD_ADC
OE from the voltage translators is connected to one of the pins in the P8 header and activated by one of the MIC (LDO) ICs.
OE
P8
MIC
Test points removed. Sensors need adjustments (rev. 1.4 sensors work fine).
Capacitor changed, signal added to POR2
POR2
Resistor changed from 10K to 100K.
10K
100K
Straight connection of the Power Module DF13-6 pins. Add CAP to the LDO. Add more resistors to the CURRENT and VOLTAGE sense lines.
CAP
(left side corresponds with
rev. 1.2
, right siderev. 1.4
):In
rev. 1.2
theVDD_ADC
is not connected properly (that signal provides 1.8 V, the voltage divider is not needed).OE
from the voltage translators is connected to one of the pins in theP8
header and activated by one of theMIC
(LDO) ICs.Test points removed. Sensors need adjustments (
rev. 1.4
sensors work fine).Capacitor changed, signal added to
POR2
Resistor changed from
10K
to100K
.Straight connection of the Power Module DF13-6 pins. Add
CAP
to the LDO. Add more resistors to the CURRENT and VOLTAGE sense lines.