Closed dkadish closed 11 months ago
Looks like I reversed the qwiic pins, at least on the board connector (J5).
Correct pinout:
My Pinout (schematic)
My Pinout (IRL, note the connector colours)
Perhaps I just chose a connector that was reversed? I should check the datasheet. Also, is this a problem on the sensor board as well?
The issue was that the model for the horizontal connector was used, when the vertical connector is the one that is actually being used. Model was swapped out and moved to a managed library with 3d model in f1e158930c921999815bc7a033bd7ceeb8bc787d
Voltage was measured at 2.2 V on the quick voltage line. Double check and see if cause can be identified.