search

donovan6000 / iMe

Third-party compatible firmware for the Micro 3D printer
GNU General Public License v3.0
60 stars 17 forks source link

Motor idle pitching sound #14

Closed stephenci closed 8 years ago

stephenci commented 8 years ago

I noticed after homing or moving the head around, the motor would emit noise higher than it would normally with m3D fio. Also M84 or hitting the "release" button doesn't not seem to do anything I was hoping it would turn the motor off and stop the noise.

qwerty8224 commented 8 years ago

I think to compare MCH and IME impossible. Since this is a completely different products))) Well, even the firmware is at an early stage, I think that in time all will be)

stephenci commented 8 years ago

Not sure if I understand you entirely on the MCH IME... I merely reporting issue I encounter here that I think can be improved

jtaylor330 commented 8 years ago

I'll second the noise and release function not working. Also if I don't Home X before printing my print (in matter control) will start centered nearly over x80y80 approximately even though it goes through homing X and Y at the start of the print it still wants to shift over and forward.

donovan6000 commented 8 years ago

iMe V00.00.01.06's motor idle pitch should be similar to that of M3D's official firmware. Also the command to turn the motors off is M18 for both iMe and M3D's official firmware.