Closed qwerty8224 closed 8 years ago
Error Mattecontrol Octoprint M33Fio
I don't understand what you mean. What's lifting team?
Skips Team Z Nozzle (extruder) does not rise
I still don't understand. What is Skips Team Z? Is it a G-code command?
iMe wont lift the nozzle if the 3D printing software doesn't send the command to make the nozzle rise. Are you sure this isn't an issue with MatterControl and OctoPrint?
It is difficult to communicate with Google translator))) I do not know what the problem is))) I think you can see the Problem in the firmware. 1.12. Before, everything was fine. I tested 1.12 Devel had no problems.
I do not understand ...... /////// 1.14 is good prints Everything works as it should.
IME 1.12 1.13 skips lifting team Check, please.