search

donovan6000 / iMe

Third-party compatible firmware for the Micro 3D printer
GNU General Public License v3.0
60 stars 17 forks source link

Invalid G codes? #55

Open erickphd opened 7 years ago

erickphd commented 7 years ago

Installed firmware on Micro then connected to MatterControl, latest stable version. Tried to run calibration cube. Job stalls after bed level and preheat. Log shows invalid G codes - print_log.txt Is this iMe firmware or MatterControl?

Kivo0 commented 3 years ago

For Anyone used the flasher on the Micro+ printer and the printer shutted down : to reinstall the factory software 1) open the M3D software then connect the printer power 2) press on update fast before printer shuts down

Good luck