HY368 thermostat mode "heat" ignores setpoint

dresden-elektronik / deconz-rest-plugin

deCONZ REST-API plugin to control ZigBee devices

BSD 3-Clause "New" or "Revised" License

1.9k stars 502 forks source link

HY368 thermostat mode "heat" ignores setpoint #3452

Closed Hypfer closed 3 years ago

Hypfer commented 4 years ago

Describe the bug

Setting the thermostat mode to heat causes it to open the valve 100% all the time with no regard for the setpoint.

Steps to reproduce the behavior

Set thermostat to heat
Observe the room getting warmer beyond the setpoint

Expected behavior

Auto should use the schedules configured in the device while heat should be manual control without schedules.

Environment

Host system: Pi 3B+
Running method: Raspbian
Firmware version: 26330500
deCONZ version: 2.05.83
Device: RaspBee I

Mimiix commented 3 years ago

@hackacad @Smanar no clue what's going on here, but should this issue remain closed?

Hypfer commented 3 years ago

I've closed this thread because the discussion was going in circles multiple times.

Decisions about the API were made. I still think that there's room for improvement there, but - as you can plainly see - opinions seem to differ on that one. Since my last horse in this race died, I've closed this thread, which would've been closed by the Stale bot anyways.

I really don't see your point nor your contributions to the community. This comment was off-topic, useless and completely uncalled for.