I've been trying to pair the LED bulbs listed in the title (article nr: 704.391.58) to my conbeeII connected to the deconz integration in home assistant, but I cannot seem to get it to work. The status lights within deCONZ seem to point at a timeout.
Steps to reproduce the behavior
I've been doing the following:
Press "Add new lights" in Phoscon
Reset the lightbulbs (off and on 6 times, the light blinks once and then starts to fade in and out in brightness)
At this point the lights don't show up in phoscon, but they do show up in deCONZ as can be seen by the screenshots.
Both devices will show a red dot in the top left grayed out dot while the light is pulsing.
Turning off and on the lights once as instructed has no effect.
Afterwards I have retried pairing without deleting the nodes from deCONZ, which left them the way they were after the first try, but also with, which made the devices reappear as they are in the screenshot.
Expected behavior
The devices are supposed to show up in deconz as connected and Phoscon should show the newly added lights.
Screenshots
Environment
Host system: Raspberry Pi
Running method: Home Assistent deCONZ Add-on
Firmware version: 26720700
deCONZ version: 2.14.01
Device: ConBee II
Do you use an USB extension cable: no, but I have tried both
Is there any other USB or serial devices connected to the host system? If so: Which?: Z-Wave.me UZB, have tried with and without.
deCONZ Logs
The following logs are captured after a fresh restart:
Describe the bug
I've been trying to pair the LED bulbs listed in the title (article nr: 704.391.58) to my conbeeII connected to the deconz integration in home assistant, but I cannot seem to get it to work. The status lights within deCONZ seem to point at a timeout.
Steps to reproduce the behavior
I've been doing the following:
At this point the lights don't show up in phoscon, but they do show up in deCONZ as can be seen by the screenshots.
Both devices will show a red dot in the top left grayed out dot while the light is pulsing.
Turning off and on the lights once as instructed has no effect.
Afterwards I have retried pairing without deleting the nodes from deCONZ, which left them the way they were after the first try, but also with, which made the devices reappear as they are in the screenshot.
Expected behavior
The devices are supposed to show up in deconz as connected and Phoscon should show the newly added lights.
Screenshots
Environment
deCONZ Logs
The following logs are captured after a fresh restart:
Additional context
So far (as you can see) I only have a single Tradfri PIR connected.