The one that I didn't remove and readd, looks like this in phoscon:
Host system: PC (NUC with PVE)
Running method: Home Assistent deCONZ Add-on
Firmware version: (26670700)
deCONZ version: (2.09.03)
Device: ConBee II
Do you use an USB extension cable: yes
Is there any other USB or serial devices connected to the host system? AEOTEC Gen5 z-wave
I have added them before upgrading to 2.09.03. They showed up as Multipurpose Sensor, and I just added 'Livingroom' in front of it.
I have two of these. As I had a minor zigbee breakdown, I had to remove one of them from the net, and readd it.
It shows up in deconz.
After readding it, it shows up in deconz as TS0201, and also in HomeAssistant (as TS0201)
The one that I didn't remove and readd, looks like this in phoscon:
I have added them before upgrading to 2.09.03. They showed up as Multipurpose Sensor, and I just added 'Livingroom' in front of it. I have two of these. As I had a minor zigbee breakdown, I had to remove one of them from the net, and readd it. It shows up in deconz. After readding it, it shows up in deconz as TS0201, and also in HomeAssistant (as TS0201)
From deconz: