RC_X_DZ Parameter lost after each reboot in 2.65 and 2.66

ducharmemetal / ardupilot-mega

Automatically exported from code.google.com/p/ardupilot-mega

0 stars 0 forks source link

RC_X_DZ Parameter lost after each reboot in 2.65 and 2.66 #804

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago

What steps will reproduce the problem?
1. Set any or all RC_X_DZ parameter to any value (tested with 0, 3,4,30)
2. Write them to APM 2.0. Read them again to check if they were stored.
3. Reset or power off APM

After reset or power off the stored RC_X_DZ parameter are on firmware defaults

This happens with V. 2.65 and 2.66

Maybe this could be the same reason as issue 718, because sometimes I found my 
stored RC_X_DZ parameters on RX_X_min ?

Original issue reported on code.google.com by Gregm...@gmail.com on 16 Nov 2012 at 2:00

GoogleCodeExporter commented 9 years ago

I confirm this problem.This happen to me for CH5 when I set RC5_function to 4 
(for second aileron setup).After reboot RC5_DZ value,if different from zero,is 
copied to RC5_min value !For this reason I have set RC5_DZ value to 
zero.(Arduplane V2.65)

Original comment by alder...@katamail.com on 17 Nov 2012 at 8:50

GoogleCodeExporter commented 9 years ago

It seems to be resolved in 2.67. In my opinion issue can be closed/deleted.

Original comment by Gregm...@gmail.com on 24 Nov 2012 at 7:56

GoogleCodeExporter commented 9 years ago

Original comment by Meee...@gmail.com on 28 Nov 2012 at 11:32

Changed state: Fixed