What steps will reproduce the problem?
1. Run the wizard
2. Fail at step 5 of 16 (or complete)
3. Try to do the calibration again by going back or forward
4. The 'Start' and 'Continue' buttons will never be enabled again.
What is the expected output? What do you see instead?
It should be possible to redo this calibration step
What version of the product are you using? On what operating system?
MP 1.2.92
Please provide any additional information below.
Another error is when one closes the wizard and run it again (when already
connected) after a failed calibration, an error pops up saying that the port is
busy.
Original issue reported on code.google.com by huj56...@gmail.com on 10 Jan 2014 at 8:32
Original issue reported on code.google.com by
huj56...@gmail.com
on 10 Jan 2014 at 8:32