Stuck instalation Raspberry Pi Zero 2W with Raspberry Pi OS Lite (32bit) BookWorm

[JLVFixer]

Linux Distribution

Raspberry Pi OS Lite (32bit) BookWorm

What happened

I'm experiencing difficulty with the Klipper installation process on my system. It appears to hang indefinitely during the "Unpacking phase of gcc-arm-none-eabi (15:12.2.rel1-1)". This occurs regardless of the type of SD card used, the power source, or the method used to install the operating system.

What did you expect to happen

Follow through and complete instalation

How to reproduce

Install Rasberry OS Lite with Raspberry Pi Imager 32bit for Raspberry Pi Zero 2W Configure SSH Follow the steps provided for KIAUH

Additional information

No response

[sa6kod]

I have the exact same problem,

Recently I got this : W: Operation was interrupted before it could finish W: APT had planned for dpkg to do more than it reported back (6 vs 97). Affected packages: bsdextrautils:armhf eject:armhf fdisk:armhf gcc-arm-none-eabi:armhf libblkid1:armhf libcamera-ipa:armhf libcamera0.2:armhf libfdisk1:armhf libmount1:armhf libpisp-common:armhf libpisp1:armhf libsmartcols1:armhf libuuid1:armhf linux-libc-dev:armhf mount:armhf pi-bluetooth:armhf raspi-config:armhf raspi-firmware:armhf raspi-utils:armhf rfkill:armhf rpicam-apps-lite:armhf util-linux-extra:armhf util-linux:armhf

[dw-0]

This is likely no issue of KIAUH. With the Information you provided, it seems to point to the system/hardware itself. The Pi Zero 2W was fine a while ago as the absolute minimum. But back then everything already took significantly longer than on a more powerfull Pi. Especially when a fresh system is set up and hundreds of MB are downloaded and unpacked.

[sa6kod]

I fixed the problem. If you rather install the Mainsail OS on the Rpi it's already preinstalled! This worked for me atleast.

(Operating System) --> "Other specific-purpose OS" --> "3D printing" -->"Mainsail OS"

[nguyencongdanh21]

Install 64-bit lite OS imager it work fine