Open stegenfeldt opened 8 years ago
Hi Samuel, did you manage to updating your microDelta printer? I am in the exact same situation (I have a microDelta printer "Original", running on a 8.3 Teensylu board, with a Repetier v0.92.5 firmware. I bought it as-is, and I therefore never had to flash it, but I would now like to customize it, in order to install a Z-probe and possibly Trinamic silent stepper drivers, but I would have to change settings in Repetier firmware to enable Trinamic's StealthChop feature.
"Kind of" I basically used the repetier configurator to generate a new config. It's not fully serviceable so I am still reverting to the 0.91 when I want reliable printing. Haven't spent much time on it, as the switch to a glass print-bed eliminated my need to probe the bed.
I'd like to add that I got a good response when mailing eMotion-tech and they gave me a few updated parts as well.
Hmm... And what about the software suite needed to build ? Do you use the latest Arduino IDE to build the Repetier after exporting it with Repetier Configurator ?
Tschüß, Yann
I believe I had to go back to... version 1.0.6? Otherwise the recommended board configs wouldn't load into the IDE. I was almost a year ago now, so memory is a bit fuzzy.
I successfully build a version of the firmware from the source of that repo with Arduino V 1.0.5 and teensy V 1.17 and I used their tool (Manual_Update_v1.75) to update the printer I just switch the .hex ... the Teensy loader dont want to work...
Now the problem is just to find the source or the v1.75 (in 0.92) because as you said, the version of that repo is at 0.91
https://www.pjrc.com/teensy/td_117/ https://data.emotion-tech.com/ftp/%C2%B5Delta_Originale/Logiciels/Windows/Firmware_updater/Manual_Update_v1.75.zip
Hi!
I was looking through the sources in the repo and noticed that the latest firmwares available seems to be based on v0.91, while the firmware I have installed using your updater is based on newer versions than that. Would it be possible to push these updates to github as well? I am about to add a Z-probe to the uDelta and I would like to base it on a fresh firmware release.