NXT 6.50 Beta Firmware Update Bugs

[papagino007]

I just installed the 6.50 Beta, did a restore, Save, then did the Motor Setup and Save, did the Throttle calibration and Save. Here is what I have found so far:

Bugs in the Power Tuning window

• Speed limit doesn't save, Eco seems to always go to 19 after save.
• When trying to change and save speed limit for ECO, the ASSIST button right to THROTTLE button sometime disappear.

Main screen bugs

• Changing KPH to MPH when taping it below battery gauge no longer switch.
• Assist levels not always appearing (Because of the bug in the Power tuning window)
• Sometime, the WATTS/AMPS/RPM selection boxes will have one that is all black with no letters (could have been caused by the screws holding the LCD display being to tight... further testing to confirm later)

BIKE /RIDE STATS Bugs

• Nothing recorded for Odometer and Trip meter, always shows 0.00km

MOTOR SETTINGS

• When clicking on the "Motor options" in the MOTOR SETTINGS window, the button to set KPH or MPH on the bottom of the screen always revert back to MPH.

I haven't had a chance to ride the bike yet as it is dark outside now, but will do more testing later.

Video showing my observation and bugs are in the link below: https://youtu.be/JXVIntQz5f4

Cheers

[papagino007]

The pre-release firmware .hex and .tft filenames are different from previous releases, can this cause a problem with the update?

[papagino007]

Also, regarding the RTC, isn't a battery needed for this, a CR1220 battery... But the battery holder is missing on my display board! Do you have a battery holder on your test Nextion display board?

If it is required, I can order one on Digikey or Amazon and solder it myself... Let me know

[papagino007]

Also, on the 6.50 change log, it mentioned that New Settings is available under

New Settings

Throttle Ramp Slider Current Ramp Slider Motor IDLE Speed Slider Assist Ramp Slider Assist Max Speed Slider Speed Sensor Selection (Use Motor for speedometer signal or use external speed sensor) Adjustable battery foldback

Will these new settings be available for all motors or only for the LR Big Block XL? (couldn't find it anywhere for the BBSHD...)

[electricrt]

Also, on the 6.50 change log, it mentioned that New Settings is available under

New Settings

Throttle Ramp Slider Current Ramp Slider Motor IDLE Speed Slider Assist Ramp Slider Assist Max Speed Slider Speed Sensor Selection (Use Motor for speedometer signal or use external speed sensor) Adjustable battery foldback

Will these new settings be available for all motors or only for the LR Big Block XL? (couldn't find it anywhere for the BBSHD...)

Those are not avaliable yet, they will be in the next iteration of the 6.50beta