design review

[gkasprow]

The project is ready for production. @michalgaska please make the review:

• [x] LDO and amplifier pin assignments
• [x] signal assignment on USB connector between AFE and Hub boards
• [x] analog signal termination
• [x] SIPM pin assignment
• [x] signal matching on IDC connector between AFE boards
• [x] signal matching between AFE boards
• [x] CAN pins assignment and transceiver connection
• [x] CPU pins assignment
• [x] LDO and current measurement

On PCB:

• [ ] make sure that fragile analog lines are away from digital ones.

[pwkolas]

Revision of v1.1rc1:

• [x] Transceiver for CAN is replaced. The new one does not use control signals (CAN_MOD, CAN_MOD2). However they are still connected to NC pads. This is left in case of using again old transceiver?
• [ ] I am not sure about USB C connector. I see it was modified. I have questions about polarity and CC pins configuration (on HUB as well).

[gkasprow]

Yes, these pins were left in case of using other transceivers Remember that USB-C have crossover http://cybuild.blogspot.com/2017/07/blog-post.html