Normally i sit on Discord Talking with my Printer Friends, and every couple of minutes someone rages that he forgot to start the print after the heatup procedure.
I normally home, then heatup bed to 95degree and let it settle for around 10min. to geht perfect first layer.
if im concentrated to the printer this is no problem BUT if someone on Discord begins a interessting topic its over with my concentration and i have to redo this procedure sometimes 3-5 times cause of the timeout.
And im definitively not alone with this issue, i know i could set the timeout higher, but actually there is also a powerconsumption and moneywise reason for this feature (lets think green)
I hope you will add this feature
many thanks in advance for your hard work
Phil2Sat
Normally i sit on Discord Talking with my Printer Friends, and every couple of minutes someone rages that he forgot to start the print after the heatup procedure.
I normally home, then heatup bed to 95degree and let it settle for around 10min. to geht perfect first layer. if im concentrated to the printer this is no problem BUT if someone on Discord begins a interessting topic its over with my concentration and i have to redo this procedure sometimes 3-5 times cause of the timeout.
And im definitively not alone with this issue, i know i could set the timeout higher, but actually there is also a powerconsumption and moneywise reason for this feature (lets think green)
I hope you will add this feature many thanks in advance for your hard work Phil2Sat