This a a whole bunch of notes from when I built the first few boards some need addressing but I can be bothered to split them all into separate Issues right now.
Badge v0.1 notes
C37 to close to the edge
C135 C127 (NP) for now
0805 Cap’s to round pads
R4 bigger size package?
R109 > C109 Silk change (typo)
R13, R2, C1 Slik move to make clear
FET's may need pull downs or pull up's
Switch D43<>D60 (Light didn't make it on to the wakeup pin as intended
PMIC control line pull up’s or down to give default states when MCU is not active driving them.
Beef up TX Line under MCU
Move L102 L105 away form 12 MHz XTAL
Inductors to 0805 round pad's?
Joystick footprint is to small for the ones from Farnell.
This a a whole bunch of notes from when I built the first few boards some need addressing but I can be bothered to split them all into separate Issues right now.
Badge v0.1 notes C37 to close to the edge C135 C127 (NP) for now 0805 Cap’s to round pads R4 bigger size package? R109 > C109 Silk change (typo) R13, R2, C1 Slik move to make clear FET's may need pull downs or pull up's Switch D43<>D60 (Light didn't make it on to the wakeup pin as intended PMIC control line pull up’s or down to give default states when MCU is not active driving them. Beef up TX Line under MCU Move L102 L105 away form 12 MHz XTAL Inductors to 0805 round pad's? Joystick footprint is to small for the ones from Farnell.