mattbrejza
commented
8 years ago | Item | Notes | Progress |
|---|---|---|
| LGA12/LGA14 footprints mirrored | Re-routing also needed | ✔ |
| switch A/B and joystick | ✔ | |
| Add option to bypass battery protection if not fitted | ✔ | |
| remove HSE and wire touchscreen | touchscreen not yet confirmed. if connecting touchscreen, make sure goes to ADC2, leaving ADC1 for user | ✔ |
| thinking we should move the LED to the bottom of the board/below the SD socket, so its not in you hand when you hold the badge; move 5mm LED more inwards | ✔ | |
| Move A, B LEDs away from screen | ✔ | |
| Add reset button for STM? | same switch as MENU? | ✔ |
| X3 is long way from mcu, check ok | ✔ - its only 32kHz, and not that far | |
| Can we get ic4 in something other than msop-10? | ✔ nope | |
| Test pad add more | add testpoints to parallel control sigs + one data ✔ | |
| Speaker too close to the edge | ✔ | |
| Move the CC serial header so its not under the screen | ||
| consider switching PA5 and PE11 for DAC on external headers | ✔ | |
| consider connecting WS2812 to a timer pin | ✔ | |
| do something with the 11 way connectors so they are in something we can buy and does not need modifying pin header socket size are normally 2,3,4,5,6,8,10.15,16,20,25 | ||
| Check if WS2812 is fine on 3.3V, otherwise move to Vbat | ✔ | |
| Check meander on usb trace | ✔ close enough | |
| Battery option 3 | ✔ | |
| R23 sort out | ✔ | |
| Test point on CC_HIB | ✔ |
dpslwk