Open CableCatDK opened 2 years ago
The settings are correct. If the power is disconnected immediately upon power up, there is at least one short-circuited mosfet. Moving the bike backwards you should feel resistance, if you also hear a mechanical noise there is something else to check.
It was a broken MOSFET. Good call :-) This is most likely completely unrelated to the firmware.
It was a broken MOSFET. Good call :-) This is most likely completely unrelated to the firmware.
is this the reason this version was suspended? what was your solution cablecatdk? did you need a brand new controller?
A new controller fixed the issue. I am running the same firmware on two other motors since the firmware was released. The only issue I noticed is that motor sometimes crashes, and need to be rebooted. In the crashed state the motor is halted, and the display is frozen.
One of my TSDZ2 stopped working:
I will investigate it further.
The motor is 5 month old and have ran 340 km.
The breakdown happed while carry a heavy load.
It was using this firmware: v20.1C.3-NEW
With these settings: