eIinx
commented
2 years ago Level1- E02 is streetmode on/off 99.9 is percentage of battery capacity (99.9 > full battery) 36.0 is battery Voltage 3.6V 00.0 km/h for about a minute is ODO compensation
Open revher opened 4 years ago
eIinx
commented
2 years ago Level1- E02 is streetmode on/off 99.9 is percentage of battery capacity (99.9 > full battery) 36.0 is battery Voltage 3.6V 00.0 km/h for about a minute is ODO compensation
Hi, I am using the latest version with the settings described on the scan of my screen. It is a new bike with a Trio German mid-motor which in fact is a TSDZ2. Everything worked fine with a backup of the original ".bin" files in case of a failure. Then flashing without errors. I already flashed a Stancecoke configuration on a old bike with success (I am also the author of the Wiki concerning the Unix and OS/X installation). As my older bike had a hub dynamo, I never tested the light from the motor. And this new installation (the mbrusa) on a new bike is the occasion to test the lights. And unfortunately when a switch the lights on (on a XH18), the lights go on but with a permanent Er 02 and the speed goes to 99.9 km/h for a few seconds and back to a steady 36km/h and still the error. Please could you tell me what I did wrong in the settings below ? Regards (meanwhile if you have time to make the wiki open again I will update the page).