I'm using revision 1336 on a Wii, via Swiss Booter, using component cables.
If launching a game or anything with a Wii with the video mode set to "NTSC", no video signal (no sync at all) is outputted when any software is using a 50Hz PAL resolution, the games and homebrew seems to still be running despite that though, and if changing it to 60Hz on the blind, video will be outputted again.
This problem doesn't occur if the Wii video mode is set to "PAL", all resolutions work fine in that case.
This problem also doesn't occur on Wii mode homebrew, even with the video mode set to "NTSC".
Steps to reproduce
1.- Make sure your Wii console is set to "NTSC" video mode.
2.- Launch Swiss.
3.- Try out any software that uses PAL video modes. (576i does have this issue too, so any PAL game should be good to test)
Expected behavior
Video signal output of PAL 50Hz signals. (Over component cables)
Describe the bug
I'm using revision 1336 on a Wii, via Swiss Booter, using component cables. If launching a game or anything with a Wii with the video mode set to "NTSC", no video signal (no sync at all) is outputted when any software is using a 50Hz PAL resolution, the games and homebrew seems to still be running despite that though, and if changing it to 60Hz on the blind, video will be outputted again. This problem doesn't occur if the Wii video mode is set to "PAL", all resolutions work fine in that case. This problem also doesn't occur on Wii mode homebrew, even with the video mode set to "NTSC".
Steps to reproduce
1.- Make sure your Wii console is set to "NTSC" video mode. 2.- Launch Swiss. 3.- Try out any software that uses PAL video modes. (576i does have this issue too, so any PAL game should be good to test)
Expected behavior
Video signal output of PAL 50Hz signals. (Over component cables)
Relevant log output
Add screenshots
No response