epigroni / superputty

Automatically exported from code.google.com/p/superputty
MIT License
0 stars 0 forks source link

Commands Not Working for multiple screens #491

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago
What steps will reproduce the problem?
1.Install
2.Open 2 Sessions
3.Issue Command in Commands Screen

What is the expected output? What do you see instead?
command to go to both sessions

What version of the product are you using? On what operating system?
1.4.0.5

Please provide any additional information below.
Accept Commands is checked in both sessions

Original issue reported on code.google.com by gregorye...@gmail.com on 19 Dec 2014 at 5:01

GoogleCodeExporter commented 8 years ago
I am using the same version with no issue.  I use the "Send Commands" toolbar 
regularly.

One thing I have noticed is that the "Send Commands" bar will not work unless 
you have the session active.

For example:  I connect to 10x Cisco CSR1000v's via telnet to console (ESXi 
Serial over IP).  When I initially open the sessions for R1 - R10, I have to go 
into each window and hit Enter on my keyboard once to activate session.  Once 
this is done, the "Send Commands" toolbar works properly.

Hope this helps.

Original comment by scottbri...@gmail.com on 31 Dec 2014 at 1:39

GoogleCodeExporter commented 8 years ago
I appreciate the comment but it doesn't work.  I run multiple commands in both 
sessions and then try a single simple command like "du -h" and it doesn't work. 
I usually have the windows side by side and I will run a command in the right 
window and then go to command bar and it still only runs the command in the 
left window. 

Original comment by gregorye...@gmail.com on 31 Dec 2014 at 1:00

GoogleCodeExporter commented 8 years ago
I'm also having difficulties with the commands toolbar. When I type or paste 
something in, it inserts characters randomly where I didn't mistype. For 
example, on my Alteon Loadbalancers, I pasted "/oper/displog ena" and got 
"/ooper/displog ena" one time and "/operea/displog ena" another time.

Original comment by michael....@gmail.com on 24 Feb 2015 at 9:05

GoogleCodeExporter commented 8 years ago
I am able to send commands to multiple windows, but the commands do not 
propagate to any windows or tabs that are on the bottom half of superputty.
Example:
    -------------
    |  A  |  B  |
    |     |     |
    -------------
    |     C     |
    -------------
The command propagates in all tabs in sections A and B, but not in section C.

Original comment by evanjtra...@gmail.com on 18 Mar 2015 at 2:14