search

eric-wieser / 2.12-robot

Final project for MIT's 2.12 - Intro to Robotics
2 stars 3 forks source link

3D print parts #17

Closed eric-wieser closed 8 years ago

eric-wieser commented 8 years ago

We need to produce:

Was it @simpri21 or @premphy who said they had access to the 3D printer?

Or should we get the TAs to print this?

simpri21 commented 8 years ago

I can 3d print if i get the step files

eric-wieser commented 8 years ago

Pulley is ready to print now!

simpri21 commented 8 years ago

Cool! I'll make a step file and print this afternoon

eric-wieser commented 8 years ago

Awesome, thanks! Slightly worried I've designed something unprintable...

Probably best to just make one for now.

Do you think you can get it done before lab hours?

simpri21 commented 8 years ago

Unfortunately not, one pulley will take 2 and a half hours to print but there's a lot of support material so it will need to sit in an acid bath for a while. Because of this I printed two so if they turn out well we won't have to print again

eric-wieser commented 8 years ago

How did they turn out? Would be good if we could check the parts fit on the servos in lab today

eric-wieser commented 8 years ago

@simpri21: Success?

simpri21 commented 8 years ago

Sorry for the delay, I went to go pick it up yesterday but the edgerton shop reset the account numbers in their system so I had to get my lab's account number before I could pick the parts up, gonna get them later this afternoon

Manny

On Tue, Nov 10, 2015 at 12:23 PM, Eric Wieser notifications@github.com wrote:

@simpri21 https://github.com/simpri21: Success?

— Reply to this email directly or view it on GitHub https://github.com/eric-wieser/2.12-robot/issues/17#issuecomment-155497667 .

eric-wieser commented 8 years ago

Did you get them then? I have the belts and bearings at my dorm now.

eric-wieser commented 8 years ago

@simpri21 Well?

eric-wieser commented 8 years ago

Make sure to bring them both with you tomorrow