Open hippertronics opened 3 years ago
I found that I couldn't get 5V at TP8 as per the calibration instructions and that the voltages didn't step in 1V steps as the switch is moved. I removed R87 (10M) and it worked fine. This was on a v2.2 board but the circuit is the same on v3.
I found that I couldn't get 5V at TP8 as per the calibration instructions and that the voltages didn't step in 1V steps as the switch is moved. I removed R87 (10M) and it worked fine. This was on a v2.2 board but the circuit is the same on v3.