search

ericpaulbishop / gargoyle

Gargoyle Router Management Utility
http://www.gargoyle-router.com
469 stars 221 forks source link

Gargoyle_1.13.x-ath79-generic-wd_mynet-n750 fails to boot after power cycle failed checksum #930

Open apassiou opened 3 years ago

apassiou commented 3 years ago

After flashing this build the unit comes up. But after the first power cycle it fails to boot. Based on serial output its a checksum error (bad flash), perhaps out of flash memory?

You can see me flashing the unit, it booting up, then on line 380 power cycling it.

log.txt

lantis1008 commented 3 years ago

When you flash the device, are you using a factory image or sysupgrade? I imagine that once you "brick" it, you're then using a factory image to recover? I note on the device wiki page it mentions that the factory image does not come back up after reboot. After initial flash, you must sysupgrade again in order to make the image usable.

Have you tried a similar process in your testing. e.g. Flash to 1.13.x, then sysupgrade to 1.13.x AGAIN before rebooting to see if it then sticks?

apassiou commented 3 years ago

I did do both, first sysupgrade, which makes it not come up even the first time. Then yeah do the reset button to put it in recovery mode and flash factory image, which results in the behavior described in the issue. I believe I tried flashing sysupgrade on top of factory image before power cycling and it resulted in same behavior, but Ill have to double check that.

lantis1008 commented 1 year ago

Please close this issue