WW0-WWPUSH wird nicht zurückgegeben

[juergen88400]

Der Wert "Warmwasser Push Warmwasserladung wird durchgeführt" wird nicht in der Integration angezeigt. Ich kann zwar sehr einfach eine Warmwasserladung starten ("WW0-WW-Push") - bekomme jedoch keine Rückmeldung. Der Switch geht nach kurzer Zeit zurück auf 0 - obwohl die Warmwasserladung startet. Das war mal anders ...

[iridium2001]

Are you sure we had this value in the integration? I can't remember that I've ever seen this. But it would be good to have it...

[juergen88400]

I did have it and it did work. I tinkered a little device with a esp8266, a button and a display. It shows on the display the temperatures of the water and the state of solar and gas water-heating. During winter I was able to have another portion of warm water outside the defined times using the button. When the button was pushed, the switch was activated and stayed in "on" position until water was warm. Now the summer sun loads my water and I did not use it until two weeks ago. Then I realized that the switch (in HA-lovelace) is immediately switching back to "off" when switched "on". And when the button on my device is pushed it activates the heating - but since the state of the switch turns immediately back to "off" it does not show the state any longer.

[erikkastelec]

@juergen88400 Is the information about the state (on/off) correct in the mobile app?

[juergen88400]

the app does not update when button is pressed outside the app - even when forced to update (drag downwards on screen) website does update when buttone is pressed outside (whether in app or in HA) but website has two entries: "Warmwasser Push Warmwasserladung wird durchgeführt" and "Warmwasser Push" looks like the information on the first one does not appear in HA integration there I see a "1" on the website when it is loading