Open vmayoral opened 9 years ago
Great, which are those cap suggetions, @proficnc?
@proficnc v1.3.1 fixes the issues we discussed yesterday. Can you provide again the values of the capacitors for the MPU6000?
Charge pump cap should be 06033C103JAT2A Reg out should be C1608X6S1C225K080AC
Can we bring this discussion back to the PXF master discussion? would be great not to fork this.
sure
@imuguruza after discussing the changes we did with @proficnc he pointed out the following (everything referred to v1.3):
LSM9D
The
Pin 1
(NC) should be disconnected.Pins 15
,16
,17
should be connected toPin 18
.MPU9250
Pin 1
should be connected to theVDD_3V3_SENSORS
lineMPU6000
@proficnc had some suggestions for the caps that could provide better results.