New ESP32-S3-Box-3 device cannot be set up with ESPHome site

[admn-monkey]

The problem

The device loads the firmware successfully, however the site never prompts for wi-fi credentials. There's no way to configure it for wi-fi so it just starts and says "No Wi-Fi". The troubleshooting QR code link does not provide a method to get it set up either. Reference documentation and YouTube videos clearly show a prompt after loading where wi-fi credentials can be put in. Without that prompt, flashing the device through the website leaves the device unable to be used.

Which version of ESPHome has the issue?

2024.5.4

What type of installation are you using?

Home Assistant Add-on

Which version of Home Assistant has the issue?

2024.5.5

What platform are you using?

ESP32

Board

Espressif

Component causing the issue

Website

Example YAML snippet

No response

Anything in the logs that might be useful for us?

No response

Additional information

No response

[vidvisionify]

Seems like the same issue as #5845

[admn-monkey]

Seems like the same issue as #5845

No, I don't believe it is. In the case I've reported, the Wi-Fi configuration never shows up. Requires a specific sequence of steps to work around that are completely silly. And the device doesn't go into a boot loop. It just sits there at a can't connect to Wi-Fi prompt on the display.

Steps to get the Wi-Fi prompt

1. Connect USB to PC then to ESP32-S3-BOX-3.
2. Press the blue connect button on the site.
3. Select the port on which Box-3 is connected and OK
4. Select install
5. After the installation is complete, press next
   1. If the wi-fi setting option does not appear, disconnect the USB from the PC.
   2. Reconnect to PC.
   3. Repeat steps 1-3
   4. Do not choose to install ; start the Console and then click Back.
   5. It should show Wi-Fi settings.
   6. If not then repeat these last steps