search

espressif / esp-drone

Mini Drone/Quadcopter Firmware for ESP32 and ESP32-S Series SoCs.
GNU General Public License v3.0
782 stars 232 forks source link

I have attached Ms5611 barometer to esp32s, how to enable altitude hold? #67

Closed saaraswata closed 1 month ago

saaraswata commented 2 months ago

Hi, I couldn't connect esp32 to the modified cfclient but was able to get gyro values using pythonlib. How to enable altitude hold mode in the drone without cfclient? I'm using esp32s Wroom 32

leeebo commented 1 month ago

refer: #34

saaraswata commented 1 month ago

I have ported ms5611 successfully and it shows that ms5611 I2C connection [OK]... However when I go to cfclient sensor plotter tab and check the barometer plotter, it seems that it's not using ms5611 for getting altitude data. When I rise the drone, the plotter goes up and then goes down to the same level. It's using mpu6050 to detect acceleration. I have a joystick and I tried to do altitude hold from cfclient too, but when I do it the drone either very slowly moved up or very slowly moved down for he target altitude. How to tell the drone to make use of the barometer instead of accelerometer. Because on startup , barometer shows correct pressure, temp and altitude in serial monitor