Power spec ultra gen 1 file format and motor direction

eugr / Flashforge-for-Cura

FlashForge Creator Pro profile for Cura 4.4+

91 stars 22 forks source link

Power spec ultra gen 1 file format and motor direction #5

Closed troyness closed 4 years ago

troyness commented 4 years ago

I tried this on my Powerspec ultra gen 1 and the bed crashed into the floor. I am actually not sure if any of the steppers were going the correct direction.

I also have the same issue as another issue opened. My printer only reads .gcode file extensions. When I setup a dreamer profile in S3D it exports a .gcode as well, so I am a little confused on the x3d format.

eugr commented 4 years ago

Are you sure it's based on FlashForge Creator/Creator Pro? If it reads only .gcode files it means that either it has different firmware (Marlin-based?) or has Octoprint built-in...

eugr commented 4 years ago

Closing due to inactivity