Open OutsiderSV opened 8 months ago
What RPi do you use?
What RPi do you use?
Sorry I have a RPi 0 WH with a waveshare v4 and pisugar 3
So strange. 1.5.6 beta v2 should work on RPi 0 WH.
So strange. 1.5.6 beta v2 should work on RPi 0 WH.
when I do the beta v2 it doesnt scan networks at all and the bottom left displays 0(0) and never updates
So strange. 1.5.6 beta v2 should work on RPi 0 WH.
when I do the beta v2 it doesnt scan networks at all and the bottom left displays 0(0) and never updates
Are you in AUTO mode?
What RPi do you use?
Sorry I have a RPi 0 WH with a waveshare v4 and pisugar 3
should look at some of the newer pwnagotchi repos 2.6.4 torch in mind
@OutsiderSV likely it is still building when you leave it there even though it doesn't look like anything is happening. The pi zero is resource constrained, so building the wheel will take ages.
My advice: increase swapsize and build in verbose mode.
Here's some notes I wrote when I got v1.5.5 working on my pi0:
Downloading numpy
will require it to compile on the RPi which will take a very long time. In order not to go insane we need to bump the swapfile so that the Pi has more memory. The process outlined below comes from here.
sudo dphys-swapfile swapoff
CONF_SWAPSIZE
from CONF_SWAPSIZE=100
to CONF_SWAPSIZE=1024
in sudo nano /etc/dphys-swapfile
sudo dphys-swapfile setup
sudo dphys-swapfile swapon
After building numpy
go back and set the swap back to 100.
Now that we have increased the swapsize we can finally upgrade numpy. This will take a very long time, so make sure to install it using --verbose
so that we can monitor the progress.
screen bash
(to exit, ctrl-a and then d. To rejoin screen -r
. To kill the session ctrl-d)sudo pip3 install --verbose --upgrade numpy --no-cache-dir
You should be good to go now!
Restart the service and boot it into Auto mode and watch the logs and you should see that the AI model now loads after about 20 minutes: sudo touch /root/.pwnagotchi-auto && systemctl restart pwnagotchi && tail -f /var/log/pwnagotchi.log
I'm pretty new to this so bare with me, I recently built my pwnagotchi and I have been reflashing trying different configurations, I am currently on version 1.5.5 but have tried beta 1.5.6 v2 the 1.5.6 does not start capturing anything while the 1.5.5 that I have currently does not have working ai, I checked the logs and this is the error I receive for the AI [2024-01-12 04:19:11,219] [ERROR] error while starting AI (numpy.ndarray size changed, may indicate binary incompatibility. Expected 44 from C header, got 40 from PyObject) Ive tried sudo pip3 install --upgrade numpy like other forums suggested but my cmd prompt keeps getting caught up at this point Running setup.py bdist_wheel for numpy ... /
I have left it at that for 2 hrs and still nothing any help is appreciated