search

exico91 / SommerESP

A plug and play ESP32-C3 board to control Sommer garage doors
MIT License
10 stars 0 forks source link

[Question] Sommer Sprint Evolution #2

Open ThomasDeMarez opened 2 months ago

ThomasDeMarez commented 2 months ago

Hi, any way this supports (or can support) the Sommer Sprint Evolution 550 line as well?

exico91 commented 2 months ago

Hello, from reading the manual I believe that is completely different from Base, pro and Evo models https://www.sommer.eu/SOMMER/Downloads/Montageanleitung/Archiv/Garagentorantriebe/sprint%20evolution/x_sprint-evolution_46721V001_EN.pdf You can probably use the pushbutton 2 and the status of the door (page 19) to get a similar behavior but since I do not have one accessible is hard to design something that works.

If you dont mind getting your hands dirty and have some basic eletronic knowledge we can make it happen

ThomasDeMarez commented 2 months ago

Hi, First of all, thanks for the quick response!

I currently have an Aqara T2 connected to terminal 5 and 6 (all DIP's off) as to simulate a button press via L1 through HA. That is working as stated in the documentation.

I've also tried using the L2 on the Aqara to terminal 6 and 7 and DIP 2 on as to have a second fake button to press. Which works, but does the same as the first button. (Both L1 and L2 are potential free) With this working, switching on DIP 7 should give me control of garage door open/stop via L1 and close/stop via L2. But the garage door is impossible to close using DIP 7 in the on position. (The open/stop does work).

The status of the door is now managed using an Aqara door sensor. I have very basic electronic knowledge. So I'm a bit stuck as for now.