The latch holes should be double checked on all versions (with wider hole on the outer sides), especially where the M3x30 goes on the enclosure base to secure the latch (see photo). The filament breaks slightly because the size of the INOX screw is too large on the far side.
So far, I have found the issue on the following versions:
The latch holes should be double checked on all versions (with wider hole on the outer sides), especially where the M3x30 goes on the enclosure base to secure the latch (see photo). The filament breaks slightly because the size of the INOX screw is too large on the far side.
So far, I have found the issue on the following versions: