Closed EYW-015 closed 3 days ago
I think the wan
interface is not needed. (I also think it should be in the same firewall zone, by the way!). Try these (in order of difficulty).
wan
is needed if you have an IP phone (NURO does not offer 光電話 AFAIK, so you don't need it). It is also not getting an IP address via DHCP4, which it would be getting if you had 光電話. You do not need wan
.
wan
from default route (i.e. uncheck "Use default gateway" from the wan
interface)wan
wan
, setting up map-e from scratchBy the way, you did not specify, I assume ipv6 works as expected, does it?
By the way, you did not specify, I assume ipv6 works as expected, does it?
Yes, ipv6 works fine.
I've tried delete the wan interface and reset the map interface. But ipv4 still can't receive any package.
@EYW-015 Did you find the way to fix the problem?
@fakemanhk Yes, I bought a new PON Stick and it worked. Some one said the VSOL-V2802RH firmware will block MAP-E traffic. https://github.com/meh301/HG8045Q/issues/2#issuecomment-2329593416
I'm using Nuro Hikari 2G, and it's on MAP-E mode. I've succeeded to configure the map-e interface and get the correct ipv4 address the same as nuro modem. But the ipv4 can't receive any data package.
I've tried to replace the
map.sh
file but not work. Seems like others were only truble in modem authenticate or MAP-E configure.The main issue https://github.com/meh301/HG8045Q/issues/2 MAP-E configure https://github.com/herrkartoffel/openwrt-jp-map-e-nuro Auto script https://github.com/site-u2023/config-software/blob/main/map-e-nuro.sh The modified
map.sh
from yours https://github.com/site-u2023/map-eIf you don't know about Nuro Hikari, just close this issue. Thank you.