I had followed your instrustion installed the driver successfully. The output shown as below:
: note: this is the location of the previous definition
CC [M] /home/pi/RTL8812BU_for_Raspbian/platform/platform_ops.o
CC [M] /home/pi/RTL8812BU_for_Raspbian/core/rtw_mp.o
In file included from /home/pi/RTL8812BU_for_Raspbian/include/drv_conf.h:17,
from /home/pi/RTL8812BU_for_Raspbian/include/drv_types.h:25,
from /home/pi/RTL8812BU_for_Raspbian/core/rtw_mp.c:16:
/home/pi/RTL8812BU_for_Raspbian/include/autoconf.h:183: warning: "CONFIG_RTW_SW_LED" redefined
#define CONFIG_RTW_SW_LED
: note: this is the location of the previous definition
LD [M] /home/pi/RTL8812BU_for_Raspbian/88x2bu.o
Building modules, stage 2.
MODPOST 1 modules
WARNING: "__sanitizer_cov_trace_cmp4" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_cmp8" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_pc" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_const_cmp4" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_const_cmp2" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_const_cmp1" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_const_cmp8" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_switch" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_cmp2" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
WARNING: "__sanitizer_cov_trace_cmp1" [/home/pi/RTL8812BU_for_Raspbian/88x2bu.ko] undefined!
CC /home/pi/RTL8812BU_for_Raspbian/88x2bu.mod.o
LD [M] /home/pi/RTL8812BU_for_Raspbian/88x2bu.ko
make[1]: leave directory“/home/pi/linux-f16e91dad2af9d57aef477cc1f522040353849f5”
pi@raspberrypi:~/RTL8812BU_for_Raspbian $ **sudo make install**
install -p -m 644 88x2bu.ko /lib/modules/4.19.97-v7+/kernel/drivers/net/wireless/
/sbin/depmod -a 4.19.97-v7+
pi@raspberrypi:~/RTL8812BU_for_Raspbian $ **sudo reboot**
The output above seen right, right?
But I still not able to get the second wlan interface:
pi@raspberrypi:/etc/network $ lsusb
Bus 001 Device 004: ID 0483:5750 STMicroelectronics
Bus 001 Device 005: ID 0bda:b812 Realtek Semiconductor Corp.
Bus 001 Device 006: ID 0424:7800 Standard Microsystems Corp.
Bus 001 Device 003: ID 0424:2514 Standard Microsystems Corp. USB 2.0 Hub
Bus 001 Device 002: ID 0424:2514 Standard Microsystems Corp. USB 2.0 Hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
pi@raspberrypi:/etc/network $ sudo iwconfig
wlan0 IEEE 802.11 ESSID:"Manal_Aruba"
Mode:Managed Frequency:5.18 GHz Access Point: BC:9F:E4:F9:95:12
Bit Rate=433.3 Mb/s Tx-Power=31 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
Link Quality=70/70 Signal level=-16 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:10 Invalid misc:0 Missed beacon:0
eth0 no wireless extensions.
lo no wireless extensions.
I had followed your instrustion installed the driver successfully. The output shown as below: