search

fatihyilmaz88 / er9x

Automatically exported from code.google.com/p/er9x
0 stars 0 forks source link

Need pot center on calibration #725

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
1. In the March 3rd update, pot center is no longer set in calibration.
2. I believe this is wrong, as the physical/visual center is usually not the 
same as the electronic center in my experience.
3. Therefore, user should still be able/required to set the desired center 
position prior to calibration.
4. Due to this, I am using version R782 which still has pot centering 
capability.
5. Without this capability, pot electronic center is usually noticeably offset 
from visual center of the knob.

Thanks.

Original issue reported on code.google.com by debak...@hotmail.com on 7 May 2013 at 5:36

GoogleCodeExporter commented 9 years ago 
It was always difficult to set the pots to their actual centre. Mechanically, 
different transmitters have the physical position of the pots rotated a bit, 
even on a single transmitter the centre of all three pots does not actually 
line up with the mechanical markings.

If the pot wasn't centered properly during calibration, you got different 
amounts of servo movement on each side for the same amount of rotation of the 
pot. The new way avoids this. You can enable BEEP CENTRE on the pots to get 
audible feedback of when the pot is actually centered.

Mike.

Original comment by michael....@mypostoffice.co.uk on 21 Aug 2013 at 8:46