bind settings not stored (?) on d4r

[fishpepper]

there are some reports on the d4r about lost/not stored bind settings, see https://www.rcgroups.com/forums/showthread.php?2735304-OpenSky-opensource-firmware-for-FrSky-D4R-ii-and-VD5M/page12

It seems like the rx does not store the bind settings for you?! Could you connect an ftdi rx pin or a spare fc rx pin (for uart3 e.g. use serialpassthrough 2 115200) and post the log during bind and one log for connecting after bind

[s3vo]

More info is here on my post on rcgroups: https://www.rcgroups.com/forums/showpost.php?p=36570934&postcount=184 here is a log from debug on D4R-II: `-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

OpenSky - BUILD_TARGET - (c) by github.com/fishpepper

uart: init done wdt: init timeout: init storage: init hal_storage: freeing i2c bus with clock train hal_storage: i2c free again storage: reading hal_storage: i2c read_buffer(0x0000, ..., 51) hal_storage: reading 51bytes: 01 5A C9 01 88 24 AB 47 CE 6A 06 8D 29 B0 4C D3 6F 0B 92 2E B5 51 D8 74 10 97 33 BA 56 DD 79 15 9C 38 BF 5B E2 7E 1A A1 3D C4 60 E7 83 1F A6 42 C9 65 00 . done. hal_storage: read done storage: loaded hoptable[] = 01 88 24 AB 47 CE 6A 06 8D 29 B0 4C D3 6F 0B 92 2E B5 51 D8 74 10 97 33 BA 56 DD 79 15 9C 38 BF 5B E2 7E 1A A1 3D C4 60 E7 83 1F A6 42 C9 65 frsky: init cc25xx: init frsky: cc25xx partnum 0x80 version 0x03 frsky: got valid part and version info frsky: configure frsky: configure done frsky: BIND jumper set = YES -> binding frsky: do bind frsky: autotune frsky: entering bind loop`

[Zebble]

This seems to be fixed. Haven't had an issue with powering off and on after binding...

[fishpepper]

fixed by 68c6e34