What steps will reproduce the problem?
1. create 31 or more poses for a six servo ax-12 "snake"
2. Load them into the sequencer
3. create a sequence and load all poses into it
What is the expected output? What do you see instead?
Should run 31+ steps in sequence editor... instead at step 31 the servos go
crazy and smash into each other then the last 1 or 2 servos in the chain turn
red (led)... I then need to unplug power to reset them... problem repeats but
if I start removing the last poses from the sequence one at a time it stops
malfunctioning when only 30 steps are in the sequence. I then tried creating a
new pose and adding the new pose as #31 in the sequence and the problem
reoccurred.
What version of the product are you using? On what operating system?
Please provide any additional information below.
Running 6 servo tentacle, single serial line of cables across all servos.
power to the arbotix is supplied by a 12v lead acid battery.
connection to pypose: Arbotix --> UARTSbee --->USB pc running win8
Original issue reported on code.google.com by fxm...@cammotion.net on 7 Nov 2013 at 8:51
Original issue reported on code.google.com by
fxm...@cammotion.neton 7 Nov 2013 at 8:51