search

flyduino / kiss-gui

Multiplatform standalone Kiss GUI
42 stars 7 forks source link

The 2.0.6 GUI doesn't show the FC-Flasher Tab when connected to v2 FC #3

Closed tobiasbischoff closed 6 years ago

tobiasbischoff commented 6 years ago

It should, or? Im on a mac.

mihauOne87 commented 6 years ago

For me works

Am 04.03.2018 um 20:02 schrieb Tobias Bischoff notifications@github.com:

It should, or? Im on a mac.

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/flyduino/kiss-gui/issues/3, or mute the thread https://github.com/notifications/unsubscribe-auth/ASOjUG9NPNnaGnLbB0Bdmp8iVpSM6JHaks5tbDowgaJpZM4Sbc72.

shermanater commented 6 years ago

I couldn't get the v2 to work on my mac. worked fine in windows but cant get the v1 to flash.

brent2658 commented 6 years ago

is there a gui for kiss v2 on the mac ? update:- my firewall was blocking the silicon labs UART driver update for MAC works great now

DroneShotFPV commented 6 years ago

Upgraded to 2.0.6 today from 2.0.0. Was running 1.32 firmware and 119d ESC firmware. Upgraded to 2.0.6 as 2.0 wouldn't work with 1.34rc FC firmware. Once I did this, after flashing to 1.34 and using 2.0.6, when I connect a battery to the quad, I can no longe rload ANY tabs in the GUI. ESC's will not flash either, gives "FAILURE: No response from FC!". I also randomly get "your firmware is older than supported by this GUI" message, but it's verified and ACTIVATED on 1.34rc. I am stuck, and cannot update ESC's, or do anything when battery is connected. Verified on both Windows 7 pro PC and Windows 10 Pro PC.

lichtl commented 6 years ago

there was an issue that the flasher was not available when connected to v1 before. This had been fixed some while ago.