Upgraded to 2.0.6 today from 2.0.0. Was running 1.32 firmware and 119d ESC firmware. Upgraded to 2.0.6 as 2.0 wouldn't work with 1.34rc FC firmware. Once I did this, after flashing to 1.34 and using 2.0.6, when I connect a battery to the quad, I can no longer load ANY tabs in the GUI. ESC's will not flash either, gives "FAILURE: No response from FC!". I also randomly get "your firmware is older than supported by this GUI" message, but it's verified and ACTIVATED on 1.34rc. I am stuck, and cannot update ESC's, or do anything when battery is connected. Verified on both Windows 7 pro PC and Windows 10 Pro PC.
Upgraded to 2.0.6 today from 2.0.0. Was running 1.32 firmware and 119d ESC firmware. Upgraded to 2.0.6 as 2.0 wouldn't work with 1.34rc FC firmware. Once I did this, after flashing to 1.34 and using 2.0.6, when I connect a battery to the quad, I can no longer load ANY tabs in the GUI. ESC's will not flash either, gives "FAILURE: No response from FC!". I also randomly get "your firmware is older than supported by this GUI" message, but it's verified and ACTIVATED on 1.34rc. I am stuck, and cannot update ESC's, or do anything when battery is connected. Verified on both Windows 7 pro PC and Windows 10 Pro PC.