kienvo
commented
3 months ago Sorry for being late. I forgot to turn on notification for this repo.
For the IC ref, not just IC1 was mismatched but all four ICs. On the PCB, two of them are missing ref, the two others were "IC1" and "U1", but they don't match up. IMO, ICs should has unified ref notations in the same schematic, so they were intentionally annotated from left to right. We could drop a short note near the regulator symbol to indicate this is "IC1" on the PCB, and so the charger.
About the regulator, I've just checked on red, yellow, and green; they are the same "665k". It was my mistake, didn't notice the part number while pulling it out from built-in symbol.
When looking at the PCB of my (violet) badge I've noticed that there is a mismatch between the PCB and the kicad schematics.
For me the silkscreen on the PCB shows the markings "KEY1" "IC1" and "C3". It seems that they refer to the three parts (button, voltage regulator, capacitor) to the left of them.
The schematics refer to the voltage regulator as "U2", I suspect this could be changed to "IC1" to match up the labels.
Also, the voltage regulator on my board is marked "665k", which refers to the 3.6V-version of the XC6206 (which also matches the measured voltage on my badge). If that part is the same for the other colors of the badge (not sure about that, different color LEDs might need slightly different voltages) the part number in the schematics could be adjusted to "XC6206P362MR".