search

fpv-wtf / wtfos-configurator

Configurator for wtfos, with built in margerine
GNU Affero General Public License v3.0
42 stars 16 forks source link

No video after Root #235

Closed arikperry closed 1 year ago

arikperry commented 1 year ago

rooted my goggles an air unit and verified it was functioning before hand. after completion ive got the lower half of the screen all snowy like an analogue signal loss and the upper half has a digital image but very poor while reading 248ms of latency. ive not found any other issues like this

stylesuxx commented 1 year ago

Yeah, that is most likely not an issue with the root. Double check that your cam is properly connected to the air unit. Also share more informations about your setup, which air unit, which goggles, what happens with other air units?

arikperry commented 1 year ago

Yeah I’d expect pretty much anyone to say that because I’d say the same thing but This is a tried and true unit. As I stated previously I turned it on before I rooted it and verified it was still working properly and it was. It’s a Runcam wasp with a full size air unit on a 10in 6s Cinelifter running Betaflight 4.3 and APD hardware. The air unit is 2months old never been crashed or wet and the DJI goggles V2 are a week old. I don’t have anything else on DJI so I can’t test the goggles against other units but I did run the BDI analogue conversion plate and it functions

stylesuxx commented 1 year ago

Could you please tell us on which versions goggle and air-unit are? I am a bit at a loss right now... Have you tried uninstallwing wtfOS? Again - I would be really surprised if it had anything to do with wtfOS. You did double check your wiring and antennas on air unit, right?

stylesuxx commented 1 year ago

Closing due to inactivity