Hi. I've only been using fritzing for a short while so apologies if the issue I'm experiencing is due to ignorance and/or mis-operation.
I'm trying to create a simple pcb from a schematic. I want it to be single sided, and I've been having issues getting all the networks to route, even when set to double sided! Yesterday I saved what I'd done. This morning I reloaded the file, checked what I'd already done, without changing anything, and then ran AutoRoute again.
It Autorouted as thought the PCB1 was set to double sided. I confirmed the Inspector settings had "one layer (single sided)" selected. I've attached the file and the schematic. Have I found a bug or am I doing something wrongly please?
RS232-RS422 Convertor.zip
Hi. I've only been using fritzing for a short while so apologies if the issue I'm experiencing is due to ignorance and/or mis-operation. I'm trying to create a simple pcb from a schematic. I want it to be single sided, and I've been having issues getting all the networks to route, even when set to double sided! Yesterday I saved what I'd done. This morning I reloaded the file, checked what I'd already done, without changing anything, and then ran AutoRoute again. It Autorouted as thought the PCB1 was set to double sided. I confirmed the Inspector settings had "one layer (single sided)" selected. I've attached the file and the schematic. Have I found a bug or am I doing something wrongly please? RS232-RS422 Convertor.zip