Hi, not an issue -- just didn't know of a better way to let you know. Anyhow, I can confirm that the integration works with following lights (THANKS!):
ESpot 120 (Eglo Crossling RGBW Spot with diameter of 120 mm, HW 4.30, firmware 2.2.6)
ETriSpot 85 (set of 3 Eglo Crossling RGBW Spots with diameter of 85 mm, HW 4.31, firmware 2.2.6)
ESpot 170 (Eglo Crossling RGBW Spot with diameter of 170 mm, HW 4.30, firmware 2.2.6)
Also, from the RPi 4B, where I run the HA, it is circa 10 meters to the lights. Integrated bluetooth on the RPi couldn't make it. So, I disabled it in the /boot/config.txt by adding a new line dtoverlay=disable-bt and connected a bluetooth adapter (any that has linux drivers/support works) on a USB extension cord (this helps to reduce the radio noise generated by the RPi). It works now.
fsaris
commented
3 years ago
Hi, not an issue -- just didn't know of a better way to let you know. Anyhow, I can confirm that the integration works with following lights (THANKS!):
Also, from the RPi 4B, where I run the HA, it is circa 10 meters to the lights. Integrated bluetooth on the RPi couldn't make it. So, I disabled it in the /boot/config.txt by adding a new line dtoverlay=disable-bt and connected a bluetooth adapter (any that has linux drivers/support works) on a USB extension cord (this helps to reduce the radio noise generated by the RPi). It works now.
So, thanks again for the integration!