How to set up a PID - Githubissues

function3d / petalot

PET Bottle To 3D Filament

Other

550 stars 75 forks source link

How to set up a PID #68

Closed Olsen-perm closed 2 months ago

Olsen-perm commented 3 months ago

Thank you for the project, it is very simple and clear. But I have a problem setting up the PID - the default values give a spread of +-5 degrees, I think that's a lot. How do I start the PID setup? Is there such a possibility?

function3d commented 2 months ago

PET filament can perfectly manufacture from 120ºC to 250ºC, +-5 degrees is perfectly normal and does not cause any problem at all.